do you have to stagger wood decking

leaving gaps between pressure treated wood deck boards

whether to leave a gap between pressure treated wood deck boards depends on how dry the wood you're using is. leave gap: if the pressure treated wood has been kiln dried after treatment (kdat), leave a 1/8” gap (the thickness of an 8-penny nail) between the boards when attaching, since the wood will expand slightly 【Get Price】

hometime how to, decks - installing deck boards

cut the first 2 deck boards to the exact length needed. the rest can run wild. if you've allowed for an overhang on the deck board, you'll have to notch out the ends of the 1st board a little to fit the cut-out in the siding, equal to the depth of the siding and the length of your overhang. that'll probably be about a half-inch deep 【Get Price】

how to install deck boards properly - youtube

apr 26, 2014 are you serious? sounds great on paper, but would require all cuts to be in a line which has been a real 'no no' for the 30 years i've been building, or double i would suggest normal single joist fixing but a pot of top quality timber preservative next to the drop saw and following each cut, dunk the lumber.【Get Price】

how to stagger deck boards home guides sf gate

any time that deck boards need to extend beyond a joist (the upright pieces supporting the deck boards), the board has to be cut to share the top of the joist with the if you do not, the deck will buckle or warp when the weather changes and the wood expands, causing damage to the deck and potentially even causing the 【Get Price】

laying out deck boards the community

mar 21, 2012 my first suggestion would be to use 5/4 x 6 x 22' decking, the wood you choose is up to you, if your store doesn't have it in stock they can order it for you. by using typically, if you're going to have butt joints on your deck boards, you want to stagger those joints randomly so they don't form a pattern.【Get Price】

the fun part: installing deck boards - wood. it's real. wood. it's

jun 13, 2016 green/wet pressure treated lumber actually feels a little moist to the touch. it will dry with time after installation. if you'd prefer to have your boards already dry, look for these letters: kdat. this means the boards were kiln dried after treatment. while it offers no guarantees, kdat lumber will improve the 【Get Price】

staggered joints for decking - decksgo

jan 9, 2009 on a 24' x 18' deck using 12' material running the 18' width is it better to stagger the joints or have all the joints on one side of the deck? if staggered, but for sure it will look better and the joints will be less obvious than if you have them all one length with a continuous joint line across the deck.【Get Price】

how to stagger deck boards hunker

oct 28, 2009 building your own deck is a satisfying achievement. for years down the line, you will be able to enjoy your deck just a little bit extra, knowing that you personally built it. one way to make your deck more aesthetically pleasing is to stagger your boards. with a staggered deck, each successive row is offset 【Get Price】

tips for how to build a deck family handyman

the traditional way most builders go about decking is to randomly stagger joints. the result is that end-to-end deck boards share the 1-1/2-in. thickness of each joist. that can cause problems, especially with wood decks. with only 3/4 in. of nailing surface, fasteners will cause ends to split, and since the board ends have to 【Get Price】

decks.com. decking patterns

depending on the decking material you are using you may need to reduce your joist spacing to 12” on center to help support the diagonal span. you may want to stagger the butt joints as best you can in different positions to reduce their visibility or use a division board to control or concentrate them in one logical location.【Get Price】